Pioneer AVIC-Z2/XU/UC Service Manual page 233

1
- Removing the Case Unit (Fig.4)
1
A
Remove the two screws and then
remove the Guide.
2
Remove the four screws.
3
Remove the five screws and then
remove the Case Unit.
4
Insert a flat screwdriver (2mm in width) selected
among precision-type screwdrivers into four
B
tabs shown below. When inserting the
screwdriver into the gap between the case unit
and the grill, push the screwdriver toward the
case unit approximately at 45 degree angle to
avoid it from contacting the grill. By doing so,
you can open the unit easily.
Caution:
When assembling the case unit, be careful not
to nip (damage) the touch-panel's tail (left side) and FFC
with back of the case.
C
- Removing the Monitor Unit (Fig.5)
1
Remove the five screws.
Disconnect the connector and then remove the
Monitor Unit.
About handling of touch panel
When replacing the touch panel
D
(hereafter, "panel") located below the LCD panel,
pay attention to the following.
- The panel is made of glass. So, be careful not to
break or damage it.
- Do not leave your fingerprints on the panel display.
- The four sides and corners of the glass panel are sharp.
So, handle it carefully to avoid any injury
E
F
226
1
2
2
3
2
3
4
1
1
AVIC-Z1/UC
2
3
Guide
3
1
1
3
Case Unit
4
4
1
Monitor Unit
3
4
2
2
4
Fig.4
1
1
Fig.5
4