Pioneer AVIC-Z2/XU/UC Service Manual page 210

5
[ Mecha ServiceTest - EDC-1 mode Layer Select - ] screen
Layer : Currently tested layer
ID : Currently tested ID
[1] Select Layer 0 Selects layer 0
• • •
[2] Select Layer 1 Selects layer 1
• • •
[3] Disc Eject Ejects the disc.
• • • • • • • •
The system escapes from the Mecha service test mode by pressing [Return] on this screen.
Though it may take some time in this case, do not press any key until the screen changes.
[ Mecha ServiceTest - EDC-1 mode - ]
Layer : Currently tested layer
ID : Currently tested ID
[1] cursor right Moves the cursor to the right.
• • • • • • • •
[2] cursor left Moves the cursor to the left.
• • • • • • • • •
[3] cursor up Moves the cursor up.
• • • • • • • • • •
[4] cursor down Moves the cursor down.
• • • • • •
[5] Start EDC-1 Starts EDC test.
• • • • • •
[6] Disc Eject Ejects the disc.
• • • • • • • • •
4. Flow of test mode for Mecha service
Flow of test mode for Mecha service
5
6
AVIC-Z1/UC
6
7
7
8
A
B
C
D
E
F
203
8