Using Your Ip Phone; Putting A Call On Hold; Ending A Call; Adjusting Volume And Muting - Cisco SPA501G Quick Start Manual

Using your IP phone

Placing or answering calls
To place or answer a call, you can pick up the receiver, press the speaker or headset button, or press a
line button (on some phones).

Putting a call on hold

To put a call on hold, press the 'Hold' button. The caller hears a series of three rapid beeps or music
while on hold. To resume the call, press the fl ashing red line button for the call. For the Cisco
SPA 502G press the 'Resume' soft key.

Ending a call

If you are using the receiver, hang up or press the 'EndCall' soft key (on some phones). If you are using
the speakerphone, press the speaker button. If you are using the headset, either press the headset
button (wired) or return the receiver (wireless).

Adjusting volume and muting

To adjust the volume of the handset or speaker, lift the receiver or press the speaker button. Press '+' on
the volume button to increase the volume, or press '-' to decrease the volume and press 'Save'. To adjust
the ringer volume, press the volume button when the receiver is on the phone and the speaker button is
off and press 'Save'. To mute the phone microphone, speaker or headset microphone, press the mute
button on the phone until the button glows red. Press the mute button again to unmute.

Using keypad shortcuts

When using the phone menus, you can use the keypad to enter the number shown next to the menu or
sub-menu item on the LCD screen (not applicable to the Cisco SPA 501G). For example, to obtain your IP
address on the Cisco SPA 504G, press the set-up button and dial '9'.
The IP address is displayed on the Network screen. Please note menus and options vary depending on
phone model.
working with daisy
0800 040 8888
www.daisygroupplc.com
v1 - 06/13