Turning Off The Power With The Sleep Timer - JVC RX-E11S Instructions Manual

Turning off the power with the Sleep
Timer
You can fall asleep while listening to music—Sleep Timer.
From the remote control ONLY:
Press SLEEP repeatedly.
• Each time you press the button, the shut-off time changes in 10
minute intervals. The SLEEP indicator lights up on the display.
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST
LPCM L C R PL
DOLBY D NEO : 6
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
10 20 30
OFF (canceled)
When the shut-off time comes:
The receiver turns off automatically.
To check or change the remaining time until the shut-off
time:
Press SLEEP once.
The remaining time (in minutes) until the shut-off time appears.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer:
Press SLEEP repeatedly so that "SLEEP OFF" appears on the
display. (The SLEEP indicator goes off.)
• The Sleep Timer is also canceled when you turn off the
receiver.
SLEEP indicator
AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
40 50 60
90 80 70
Basic adjustment of auto memory
This receiver memorizes sound settings for each source:
• when you turn off the power,
• when you change the source, and
• when you change the analog/digital input mode (see page
10).
When you change the source, the memorized settings for the
newly selected source are automatically recalled.
The following can be stored for each source:
• Analog/digital input mode (see page 10)
• Speaker output level (see page 21)
• Subwoofer audio position (see page 12)
• Subwoofer phase (see page 22)
• Digital equalization pattern (see page 22)
• Bass boost (see page 22)
• Input attenuator mode (see page 22)
• Surround/DSP mode selection (see pages 28 and 29)
NOTE
If the source is FM or AM, you can assign a different setting
for each band.
Signal and speaker indicators on the display
Signal indicators
L C R
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS
S . WFR LFE
LPCM L C
DOLBY D
S . WFR LFE
DTS AAC
LS SB RS
LS SB RS
96 / 24
The signal indicators light up as follows:
L: • When digital input is selected: Lights up when the
left channel signal comes in.
• When analog input is selected: Always lights up.
R: • When digital input is selected: Lights up when the
right channel signal comes in.
• When analog input is selected: Always lights up.
C: Lights up when the center channel signal comes in.
LS*: Lights up when the left surround channel signal comes
in.
RS*: Lights up when the right surround channel signal comes
in.
SB: Lights up when the surround back channel signal
comes in.
LFE: Lights up when the LFE channel signal comes in.
* When monaural surround signal comes in, only "S" lights up.
The speaker indicators light up as follows:
• The subwoofer indicator ( S . WFR
"SUBWOOFER" is set to "SUBWFR :YES." For details, see
page 16.
• The other speaker indicators light up only when the
corresponding speaker is set to "SML (small)" or "LRG
(large)," and also when required for the current playback.
Speaker indicators
L C R
S . WFR LFE
R PL
NEO : 6
DSP 3D
LS SB RS
AUTO SR
) lights up when
13