Table of Contents
Advertisement
When operating the receiver
using the remote control, set
the mode selector to
"AUDIO/TV/VCR/DBS."
Adjusting the subwoofer audio
position
If the subwoofer sound is reinforced for stereo sound compared to
the sound reproduced with multi-channel, set the subwoofer audio
position. The subwoofer output level is automatically decreased by
the selected value when you are listening in stereo.
The AUDIO P. indicator lights up when this function is activated.
• Once you have made an adjustment, it is memorized for each
source.
From the remote control ONLY:
Press SOUND, then press A.POSITION repeatedly.
• Each time you press A.POSITION, the subwoofer audio position
level changes as follows:
AUDIO P. indicator
EQ
C.TONE VIRTUAL SB
AUDIO P.
BASS TA NEWS INFO RDS TUNED ST
PL
LPCM
L
C
R
DOLBY D
NEO : 6
S . WFR
LFE
DSP 3D
DTS AAC
LS SB RS
96 / 24
AUTO SR
–2
OFF (canceled)
The smaller the number becomes, the more the level decreases
automatically when listening in stereo.
• If no adjustment is required, select "OFF" (initial setting).
12
NOTES
• The maximum subwoofer output level is –10 dB.
• This function is not available when the Surround/DSP mode is
• After pressing SOUND, the numeric buttons work for sound
Turning off the sounds temporarily
From the remote control ONLY:
Press MUTING to turn off the sound through all
connected speakers and headphones connected.
"MUTING" appears on the display and the volume turns off.
To restore the sound, press MUTING again.
• Pressing VOLUME +/– (or turning MASTER VOLUME control
Changing the display brightness
You can dim the display—Dimmer.
Press DIMMER repeatedly.
• Each time you press the button, the display brightness changes
AUTO MUTING
SLEEP
AUTO MODE
ATT
HP
MHz
kHz
–4
–6
Ex.: When setting the subwoofer output level to "–8 (dB)" and
the subwoofer audio position to "–4 (dB)," the subwoofer
output level when listening in stereo will be –10 dB.
To adjust the subwoofer output level, see page 21.
activated.
adjustments. To use the numeric buttons to operate your target
source, press the corresponding source selecting button before
operation; otherwise, the remote control may not work as you
intend.
EQ
C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST
LPCM
L
C
R
PL
DOLBY D
NEO : 6
S . WFR
LFE
DTS AAC
DSP 3D
LS SB RS
96 / 24
AUTO SR
on the front panel) also restores the sound.
as follows:
DIMMER 1:
Dims the display slightly.
DIMMER 2:
Dims the display more than DIMMER 1.
DIMMER 3:
Turns off the display. (Temporarily canceled
when you operate the receiver.)
DIMMER OFF: Cancels the Dimmer (normal display).
AUTO MUTING
SLEEP
AUTO MODE
ATT
HP
MHz
kHz
Hide quick links:
Advertisement
Table of Contents
