Sound Adjustments; Basic Adjustment Items; Operating Procedure - JVC RX-E11S Instructions Manual

Sound adjustments

You can make sound adjustment to your preference after
completing basic setting.

Basic adjustment items

You can adjust the following items. See pages in parentheses for
details.
• You cannot select the items which is not available with the
current setting.
Items To do
SUBWFR LVL Adjust the subwoofer output level. (21)
FRONT L LVL* Adjust the left front speaker output level.
(21)
FRONT R LVL* Adjust the right front speaker output level.
(21)
CENTER LVL* Adjust the center speaker output level. (21)
SURR L LVL* Adjust the left surround speaker output level.
(21)
SURR R LVL* Adjust the right surround speaker output
level. (21)
EFFECT Adjust the effect level. (21)
PANORAMA Add "wraparound" sound effect with side-
wall image. (21)
BASS BOOST Boost the bass level. (22)
INPUT ATT Attenuate the input level of analog source.
(22)
CENTER TONE Make the center tone soft or sharp. (21)
D EQ 63Hz Adjust the equalization pattern of each
D EQ 250Hz band. (22)
D EQ 1kHz
D EQ 4kHz
D EQ 16kHz
SBWFR PHASE Select the subwoofer sound phase. (22)
* If you have used Smart Surround Setup on page 14, these
settings are not required.
You can also use the remote control for sound adjustment
except for "PANORAMA," "INPUT ATT," and "SBWFR PHASE."
20

Operating procedure

On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
Ex.: When adjusting subwoofer output level.
1
Press ADJUST.
MULTI JOG now works for the sound adjustment.
2
Turn MULTI JOG until the item you want to
adjust appears on the display.
• As you turn MULTI JOG, the adjustment items change as
follows:
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST
PL
LPCM L C R
DOLBY D NEO : 6
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
SUBWFR LVL
FRONT R LVL
SURR L LVL
EFFECT
BASS BOOST
CENTER TONE
D EQ 250Hz
D EQ 4kHz
SBWFR PHASE
• The items which is not available with the current setting will
be skipped.
3
Press SET.
The current setting for the selected item appears.
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST
LPCM L C R PL
NEO : 6
DOLBY D
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
4
Turn MULTI JOG to adjust the selected item.
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST
PL
LPCM L C R
DOLBY D NEO : 6
S . WFR LFE
DSP 3D
DTS AAC
LS SB RS
96 / 24 AUTO SR
Your adjustment is stored.
5
Press SET.
6
Repeat steps 2 to 5 to adjust other items if
necessary.
AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
FRONT L LVL
CENTER LVL
SURR R LVL
PANORAMA
INPUT ATT
D EQ 63Hz
D EQ 1kHz
D EQ 16kHz
(Back to the beginning)
AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
–10
0 +10