Listening To Radio Broadcasts; Selecting A Radio Station - JVC DD-3 Instructions Manual

Listening to radio broadcasts

* For the number button usage, refer to "Using the
number buttons" on page 16.
■ CAUTION
• Slide the remote control mode
selector to [AUDIO].

Selecting a radio station

1
Press [FM/AM] to select "FM" or
"AM" in the display window.
• Each time you press [FM/AM], the band tog-
Remote control
• Repeatedly pressing [SOURCE] on the
mode selector
Example: Display when an FM radio broadcast
Preset number (Refer to page 21.)
Number
buttons*
2
Press [
repeatedly to select a radio sta-
tion.
• When the main unit has receive an FM ste-
• You can also select a radio station using the
■Automatic tuning
Hold down [
the frequency starts changing, and then
release the button.
• When the main unit has received a broad-
• You can select a specific radio station while
NOTE
• If an FM stereo broadcast is difficult to hear
because of noise, you may be able to hear the
broadcast more easily by pressing [FM MODE]
to switch the sound to monaural reception. In
this case, the "MONO" (monaural) indicator
lights up in the display window. To return the
sound to stereo reception, press [FM MODE]
again.
gles between "FM" and "AM".
main unit can also select a radio broadcast
as the source.
is received
Stereo indicator
Frequency (M: MHz/k: kHz)
TUNING] or [TUNING
reo broadcast, the "ST" (stereo) indicator
lights up in the display window.
automatic tuning.
TUNING] or [TUNING
cast, the frequency automatically stops
changing.
searching for a broadcast. Press [
ING] or [TUNING ] to stop the automatic
tuning when the desired frequency appears
in the display window.
]
] until
TUN-
20