Musicom Lab EFX MKII User Manual page 9

* The EPL channel and number are global (the same for all banks/presets). you need not edit
these for any other banks/presets if you have already done so.
①
Press/hold the FS-1 switch(FS, function select) to edit the
is shown on the display if you are already in the Edit Mode.
②
Press the PS-2 switch(CH, channel) to set a
current EPL channel.
③
Press/hold the BANK UP or BANK DOWN switches to select a channel from 1 through 16.
④
Press the PS-2 switch to store a new channel in memory. The LED above the PS-2 switch
will flash 2 times.
⑤
Press the PS-4 switch(CC, control change) to set a
current EPL number.
⑥
Press/hold the BANK UP or BANK DOWN switches to select a
127 or OFF.
⑦
Press the PS-4 switch to store a new
switch will flash 2 times.
The cable required is a stereo (TRS) to two mono 1/4" phone plugs. Connect the tip(stereo plug)
to the pedal input, ring to the pedal output and sleeve to ground on all 3 plugs.
Note
* OFF means no Control Change is transmitted.
* The last decimal point on the display means that the display shows a PCs or CCs number.
* The Initial default channel setting of the EPL is channel 1.
* The Initial default number setting of the EPL is OFF.
EFX MkII Audio Controller User Manual
EPL for the XPDL port until the EPL
EPL channel number. The display will show a
EPL number. The display will show a
EPL number in memory. The LED above the PS-4
EPL number from 0 through
9