Electromechanical Unit Wire Connections - Daikin ARQ Installation Manual

ElectroMechanical Unit Wiring
Connections
Electromechanical control connections are made to the terminals located
behind the left-front access panel as shown in Figure 68. Refer to the
wiring diagram (Figure 69) for wiring details and the wiring diagram
provided with the unit.
Figure 68: Thermostat Control Terminal Connections
Located in Left Front Compartment
Figure 69: Typical ElectroMechanical Wiring Diagram -
Model AR, Thermostat Control with Normally Open Heat,
460 Volt - 3Phase
Page 36 of 42
Terminal Connections for
Electromechanical Controls
Self-Contained WSHP Unit Ventilator Models ARQ, ERQ, GRQ
CAUTION
Refer to unit wiring diagram located on inside of right front panel,
for actual wiring. Improper wiring can cause equipment and property
damage.
DANGER
Disconnect all electrical power before servicing unit to
prevent injury or death due to electrical shock.
Use copper conductors only. Unit terminals are not designed to accept
other types of conductors. Failure to do so may damage the equipment.
Legend
Plug In
Splice
Tap Conn.
Term Conn.
Capped Wire
CAUTION
Comp Tie Point
Optional Wiring
Wired by Others
Factory Wired
Ground
IM 1083