How To Change The Ip Address - ATCOM IP-PBX series Quick Start Manual

How to change the IP address

The default IP the IP-PBX is 192.168.1.100. Your network may have a different IP range such as
192.168.10.xx. In this case, you will not be able to configure the IP-PBX if you put it directly into
your LAN. You can change the ip address of IP-PBX to make it in the same network segment as
your LAN.
Steps:
1) Connect the IP-PBX's WAN port to your PC.
2) Use putty to access to the IP-PBX via SSH.
3) Run below Linux command to change the IP-PBX's IP to fit your network.
root:~> ifconfig eth0 IP_Address
replace IP_Address with a valid IP in your LAN ( if your LAN has the ip segment 192.168.10.xx,
then you will properly put 192.168.10.100 here)
4) After Step 3) is done, the IP-PBX will have a temporary IP but it will lose change after reboot.
To change its IP permanently you need to change the IP from the Web GUI. The page to
configure the IP address is:
Go to Options--> Advance Options-->Show Advance Options. Then you can find the network
settings in the main menu.
There are three types for network settings:
a) DHCP: Yes IP04 will obtain the dynamic IP from your router.
b) DHCP: auto IP04 will use the static IP specified below and ping the default gateway,
when there is no response from the default gateway. The IP04 will switch to dynamic
obtain the IP from your router.
c) DHCP: No IP04 will use the static IP specified below.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299