Rear View - Rena MACH 5 Operation Manual

SECTION 1
GETTING ACQUAINTED

Rear View

Main Power Switch, Receptacle and Fuse – Plug in AC power cord here. Switch turns main
power ON/OFF. Fuse provides over-current protection. Fuse rating: 2.5A, 250V, slow blow.
CAUTION: Make sure power cord is disconnected from printer before checking/replacing fuse.
1.
WARNING: Press the ON/OFF Button, located on the control panel, to properly power-down the
print engine. Wait until all control panel lights turn off, before you turn off the main power
switch.
For best system performance, it is recommended to keep the print engine powered-up at all times.
2.
USB Port Connection – (USB 2.0) The USB cable attaches to the printer here.
3.
Network Connection – (Ethernet) The network cable plugs in here.
Sheet Separators – Used to separate a single piece of media from the stack. There are four sheet
4.
separators on this printer.
Feed Rollers – Used to deliver the bottom piece of media from the stack, through the sheet
5.
separation area, and present it to the first set of transport rollers.
Media Support Wedge Thumb Screw – Used to secure the Media Support Wedge to the Rear
6.
Media Support Guide.
Counter – LCD displays number of pieces fed into the Print Engine. Reset button zeros counter.
7.
NOTE: The number of pieces fed will normally be higher than the number of pieces printed.
Rear Media Support Guide Knob – Attaches the Rear Media Support Guide to the body of the
8.
printer.
2