Lighting Instructions - Valor 534XAN Installation & Operating Instructions Manual

WARNING: If you do not follow these instructions exactly, a fi re or explosion may result
causing property damage, personal injury or loss of life.
This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions
A.
exactly. To save energy, turn the pilot off when not using the appliance.
BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the fl oor because
B.
some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fi re department.
Use only your hand to push in or turn the control knobs. Never use tools. If the controls will not push in or
C.
turn by hand, don't try to repair them; call a qualifi ed service technician. Force or attempted repair may result
in a fi re or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and to replace any part of the control system and any gas control, which has been
under water.
1. STOP! Read the safety information above.
2. Set the fl ame adjustment knob as far clockwise
3. Turn the gas control knob clockwise
NOTE: The knob cannot be turned from PILOT to OFF unless
it is pushed in partially. Do not force.
4. Wait fi ve (5) minutes to clear out any gas, then, smell for gas,
including near the fl oor. If you smell gas, STOP! Follow
"B" in the safety information above. If you don't smell gas,
go to the next step.
5. Find the pilot. It is at the left side of the fi rebox, viewed through slotted hole in front log.
6. Push in and turn the gas control knob counter clockwise
position.
7. Keep pushed in for a few seconds to allow gas to fl ow then, keeping knob depressed, turn to PILOT to light
pilot. Hold knob in for a further 5 seconds then release. The knob should pop back out. Pilot should remain
lit. If pilot goes out, repeat steps 3 through 7.
– If knob does not pop out when released, stop and immediately call your service technician or gas supplier.
– If pilot lights but will not stay lit after several tries, turn the gas control knob to OFF and call your service
technician or gas supplier.
8. When pilot is lit, partially depress the knob and turn to ON position (Burner alight).
Do not leave knob set between PILOT and ON.
9. Set the fl ame height to desired setting*.
1. Set the fl ame adjustment knob as far clockwise
2. Push in the gas control knob slightly and turn clockwise
* The fl ame height can be increased or decreased by depressing the remote control hand set button.
38 38

Lighting Instructions

FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
to OFF.
TO TURN OFF GAS TO APPLIANCE
as possible*.
Flame
Adjustment
Knob
until resistance is felt just before the IGN
as possible*.
to OFF. Do not force.
Gas
Control
Knob
Thermocouple
probe must be
in flame