Location - Valor 534XAN Installation & Operating Instructions Manual

Framing
The framing dimensions are shown in Figure 4.
• A non-combustible hearth is not necessary in
front of this appliance.
• Note that the unit is installed at the framing
stage and fi xed to framing using support
angles. See fi gures 26 and 30. Wall fi nish is
then installed over the support angles up to
the black frame on the unit.
NOTE: If using a 612DKA or
a 613CCB front, refer to the
kit's instruction manual for
framing dimensions.
Rear Vent Connection—Flat on Wall
See fi gure 5.
Requires standard vent kit #551DVK only.
The horizontal vent run cannot be extended by the use of any vent accessory pipes.
Rear Vent Connection—Flat on Wall with Snorkel Termination
See fi gure 6.
For use on horizontal installations where the outsides ground level is too close to the standard terminal. Adapter
#817VAK, a pipe length and snorkel termination will be required. See venting accessories list on pages 39–40 for
allowable components.
16"
(41 cm)
min.
Figure 5 Rear vent—fl at on wall
10 10

Location

Figure 4 Framing
14" (36 cm) max.
combustible wall
26" (66 cm) max.
non-combustible wall
23-1/8"
(58.7 cm)
29-3/4"
to Wall Finish
16" min. straight
out or off the top.
Allow for elbow if
rear vent with rise.
16"
(41 cm)
min.
Figure 6 Rear vent—fl at on wall with snorkel
Wall Finish
33-3/4"
to header
This is the framing
35-1/2"
width. Wall finish
to 32-3/16" wide.
14" (36 cm) max.
combustible wall
26" (66 cm) max.
non-combustible wall
36" (91.4 mm) or
14" (35.6 mm) rise
(See venting accessories
options at the end of this
manual)
23-1/8"
(58.7 cm)