Wireless Key Programming Templates - ADEMCO Vista-10P Installation And Setup Manual

Installation Instructions
Zn ZT RC IN: L
10 00 10 RF 1
10 INPUT S/N: L
A XXX- XXX –
Zn ZT P RC In L
10 03 1 10 RF: 1s

Wireless Key Programming Templates

This procedure programs the wireless keys, but a key is not active until it is assigned to a user
number (see System Operation section, assigning attributes command).
If the D key was previously pressed (from *58 Menu mode) to enter and duplicate 5804 and/or
5804BD wireless keys, the following screens appear.
TEMPLATE ?
1–6 1
L 01 02 03 04
T 23 22 21 23
ENTER START ZONE
00 = QUIT 36
5-4
A summary screen with the selected zone's current programming appears.
Begin programming zone information as follows:
Enter Zone Type (ZT; see Zone Types listed in *56 Menu Mode "Zone Type" prompt), Report
Code (RC), and Input Device Type (IN)* sequentially (Loop Number (L) is entered at the next
prompt).
• Use the [A] (Advance) and [B] (Back) keys on the keypad to move the cursor within the
screen.
• Use the [C] key to copy the previous zones attributes.
* If HW (hardwired) or AW (Auxiliary) is entered for Input Device Type, the display will be
similar to the prompt shown, except that HW or AW will be under "IN".
Press [ ∗ ] to save the programming and continue. If needed, press the [#] key to back up
without saving.
For wireless devices (input types RF, UR, BR), continue to the serial number/loop number
prompt.
For wired devices, return to the initial summary screen prompt to begin programming the
next zone.
Manually enter the serial number (found on the transmitter label), by typing digits in the
"X" locations, using the [A] (advance) or [B] (back) keys as required.
OR
Transmit two open/close sequences. If using a button-type transmitter, press and release
the button twice, but wait about 4 seconds before pressing the button the second time.
If you want to copy the previous zone's serial number, press the [C] key.
Press [ ∗ ] to advance to the loop number, then enter loop number.
Press [ ∗ ] to accept the existing serial and loop number and continue to the "Confirm"
prompt described in *56 Menu mode above.
If necessary, press [#] to back up and re-enter or edit the serial number.
If the serial number transmitted matches the serial number entered, the keypad will beep 3
times and a summary display will appear, showing the programmed information for that
zone.
Press [ ∗ ] to begin programming the next zone. See first "Summary Screen" prompt
paragraph.
Enter desired template number 1–6 (see chart).
Press [#] if you want to return to *58 Menu mode Summary Screen.
If necessary, press [#] to back up and re-enter template number.
Press [ ∗ ] to continue to template display.
The selected template is displayed.
Top line of display represents loop numbers, bottom line represents zone type assigned for
each loop.
Press [ ∗ ] to accept template and continue.
The system will search for the highest available consecutive 4-zone group (the four zones in
the case of the 5804 and 5804BD), and display the lowest zone number of the group.
If you want to start at a different zone, enter the zone desired, and press [ ∗ ]. If that zone
number is displayed, the system has the required number of consecutive zones available,
beginning with the zone you entered. If not, the system will again display a suggested zone
that can be used.
If the required number of consecutive zones is not available at all, the system will display
"00".
Press [ ∗ ] to accept and continue.