Programming The Wireless Receiver - ADEMCO VISTA-50P Installation And Programming Manual

Installing the 5800TM Module
5800TM Wiring Connections

Programming The Wireless Receiver

–44–
Installation of this module is necessary only if you are using one or more 5827BD
Wireless Bi-directional keypads.
The 5800TM must be located between one and two feet from the 4281 or 5881
receiver's antennas. The 5800TM must not be installed within the control
cabinet. Mount the unit using its accompanying mounting bracket.
Connect the 5800TM to the control panel's keypad connection terminals, using
the supplied connector with flying leads, as follows:
WIRE
RED (+12VDC)
BLACK (Ground)
GREEN (Data to Control)
YELLOW (Data from Control)
BLUE: Not Used
Cut the red jumper for address setting 28; cut the white jumper for address 29;
cut both jumpers for address 30.
This address must be enabled as an alpha keypad in the control's Device
Programming mode and then assigned to a partition, as described later in this
section.
For additional information, refer to the 5800TM's instructions.
1. With at least one two-line alpha keypad (5137AD/6139) wired and set to a
proper address, power up the system temprarily by plugging the AC
transformer into a 120VAC outlet (previously wired to the control).
2. Enter data field programming mode: Installer Code + 8 0 0 .
a. If using a 4281: set data field 1*32 to 1
If using a 5881: set data field 1*32 to 2
b. Set data field 1*30 RF RCVR CHECK-IN INTERVAL (02-15 times 2 hrs.).
3. From data field programming mode, press #93 to display the "ZONE
PROG?" prompt.
prompt appears. Follow the instructions below.
DEVICE PROG?
1=yes 0=no
DEVICE ADDRESS?
01-31
DEVICE TYPE
RF EXPANDER
HOUSE ID XX
TERMINAL ON CONTROL
Terminal 6
Terminal 7
Terminal 8
Terminal 9
Press 0 (NO) repeatedly until the "DEVICE PROG?"
Press 1 to enter DEVICE PROGRAMMING mode.
Enter the 2-digit device address number as set by
the receiver's DIP switches (01-07). Press * to
continue.
Enter device type 03 = RF Expander.
Press * to continue.
Enter the 2-digit house ID (00-31) as determined by
sniffer mode (use an ID not displayed during sniffer
mode, as explained later in this section). Applies
only to 5700 series systems or if using a wireless
keypad (5827/5827BD) with 5800 series systems.
Press * to continue.
The system will now prompt for the next device
address to be programmed.