Configuring The Ip Addresses - Sun Oracle Sun Storage 2500-M2 Arrays Hardware Installation Manual

Configuring the IP Addresses

The serial port Service Interface menu enables you to set up the IP address
configuration for the Ethernet port on the controller.
To set up the IP address configuration for the Ethernet port on each controller:
1. Select option 2, Change IP Configuration:
Service Interface Main Menu
==============================
1) Display IP Configuration
2) Change IP Configuration
3) Reset Storage Array (SYMbol) Password
Q) Quit Menu
Enter Selection: 2
2. Specify that you do not want dynamic IP addressing, using a DHCP server, used
for this port:
Configure using DHCP? (Y/N): n
The current or default IP configuration for the selected Ethernet port is displayed.
3. Enter the static IP address and, optionally, a subnet mask for the Ethernet port:
Note – If you are not using DHCP IP addressing and have a gateway IP address on
your subnet, you must also specify a gateway IP address for the Ethernet port. This
option displays only if the serial interface detects a gateway.
Press '.' to clear the field;
Press '-' to return to the previous field;
Press <ENTER> and then ^D to quit (Keep Changes)
IP Address
Subnet Mask
Gateway IP Address if1:
4. When prompted, confirm the specified IP addressing.
The Service Interface menu is refreshed.
66 Hardware Installation Guide • June 2011
Current Configuration
if1 : 192.168.128.101
if1 : 255.255.255.0
New Configuration
IP-address
<ENTER>
<ENTER>