Table of Contents
Advertisement
Test Write Multiple Output Pins
–
Click the radio button- Multiple-Pins.
–
Key in the pin number from '0x01' to '0x0F' to choose the multiple pin num-
bers to write the value of the output pin. The pin numbers are ordered bit-
wise, i.e. bit 0 stands for GPIO 0, bit 1 stands for GPIO 1, etc. For example, if
you want to write pin 0, 1, and 3, the pin numbers should be '0x0B'.
–
Key in the value in (R/W) Result field from '0x01' to '0x0F' to write the value
of the output pin. The pin numbers are ordered bitwise, i.e. bit 0 stands for
GPIO 0, bit 1 stands for GPIO 1, etc. For example, if you want to set pin 0
and 1 high, 3 to low, the pin number should be '0x0B', and then you should
key in the value '0x0A' to write.
–
Click the WRITE GPIO DATA button to write the GPIO output pins.
2
4.3.4.5
I
C
When the application is executed, you can read or write a byte of data through I
devices. All data must be read or written in hexadecimal system.
Read a byte
–
Key in the slave device address in Slave address field.
–
Key in the register offset in Register Offset field.
–
Click the READ A BYTE button and then a byte of data from the device will
be shown on the Result field.
Write a byte
–
Key in the slave device address in Slave address field.
–
Key in the register offset in Register Offset field.
–
Key in the desirous of data in Result field to write to the device.
–
Click the WRITE A BYTE button and then the data will be written to the
device through I
PCM-9588 User Manual
2
C.
44
2
C
Advertisement
Table of Contents
