Table of Contents
Advertisement
KX-FPC135 / KX-FPC141
10.6. When LINKing
When LINKing from the Handset (when becoming STBY to
TALK), DATA is transmitted in above format. The combined
portion of DATA 0 and DATA 1 is transmitted in LINK
requesting DATA (40bit) format first. Then, when LINK OK
(ACK-OK) DATA (46bit) is returned from the Base Unit, it is
sent as LINK from DATA after changing the combination of
DATA 0 and DATA 1. And the DATA Delimit is between each
Frame as a stop.
The contents of LINK requesting DATA and LINK form DATA
are different depending on each operation.
10.7. Pulse Dial
When executing Pulse Dial, the Pulse Dial DATA is transmitted
from the Handset to the Base Unit in above format. The
combination of DATA 0 and DATA 1 are changed by each Dial
No. And the DATA Delimt is between each Frame as a stop.
The number of Frame is 2.
10.8. Tone Dial
When executing Tone Dial, Tone Dial DATA is transmitted from
the Handset to the Base Unit in above format. The DATA is
changed by Dial No. as same as Pulse Dial. When Tone
Dialing, DATA (Continue DATA) that the key is pressed
continuously is sent to the Base Unit during the key is pressed.
When depressing the key, the END data is sent finally.
Note:
1,000,000 kinds of the security code are available for the
mode KX-FPC135/KX-FPC141. Each time the Handset is
set on the cradle of the base unit (for charging), the CPU
automatically change the security code.
10.9. FREQUENCY TABLE (MHz)
214
Advertisement
Table of Contents
Troubleshooting
