Panasonic KX-FPC135 Service Manual page 184

KX-FPC135 / KX-FPC141
Bit No.
35
36
37
38
39
40
41
42
43
44
45
46
47
48
Note 1 - Standard facsimile units conforming to T.2 must have the following capability : Index of cooperation (IOC)=264.
Note 2 - Standard facsimile units conforming to T.3 must have the following capability : Index of cooperation (IOC)=264.
Note 1 - Standard facsimile units conforming to T.4 must have the following capability : Paper length=297 mm.
Signal
Training 1
TCF
(Training Check)
CFR
(Confirmation to
Receive)
Training 2
Image Signal
RTC
(Return to Control)
EOP
(End of Procedure)
MCF
(Message
Confirmation)
DCN
(Disconnect)
MPS
(Multi-Page Signal)
PRI-EOP
(Procedural Interrupt-
EOP)
PIP
(Procedural Interrupt
Positive)
DIS/DTC
Recording width capability 864 picture elements
along scan line length of 107 ± mm 1%
Recording width capability 1728 picture
elements along scan line length of 151 ± mm
1%
Recording width capability 1728 picture
elements along scan line length of 107 ± mm
1%
Reserved for future recording width capability.
Reserved for future recording width capability.
Extend field
R8×15.4 lines/mm
300×300 pels/25.4 mm
R16×15.4 lines/mm and/or 400×400 pels/25.4
mm
Inch based resolution preferred
Metric based resolution preferred
Minimum scan line time capability for higher
resolutions
"0" : T = T "1" : T = 1/2T
15.4 7.7 15.4
Selective Polling capability
Extend field
Identification Signal Format
———————
———————
X0100001
———————
Refer to the next page.
———————
X1110100
X0110001
X1011111
X1110010
X1111100
X0110101
Middle 864 elements of 1728 picture elements
Invalid
Invalid
Extend field
R8×15.4 lines/mm
300×300 pels/25.4 mm
R16×15.4 lines/mm and/or 400×400 pels/25.4
mm
Resolution type selection
"0" : neritic based resolution
"1" : inch based resolution
DonÕt care
DonÕt care
7.7
Set to "0".
Extend field
A fixed pattern is transmitted to the receiving side at a
speed (2400 to 9600 bps) designated by DCS, and the
receiving side optimizes the automatic equalizer, etc.,
according to this signal.
Sends 0 continuously for 1.5 seconds at the same speed
as the training signal.
Notifies the sending side that TCF has been properly
received. If TCF is not properly received, FTT (Failure To
Train) X0100010 is relayed to the sender. The sender
then reduces the transmission speed by one stage and
initiates training once again.
Used for reconfirming the receiving side like training 1.
Sends 12 bits (0...01 × 6 times) to the receiver at the
same speed as the image signal and notifies completion
of transmission of the first sheet.
End of one communication
End of 1 page reception
Phase E starts.
Completion of transmission of 1 page. If there are still
more documents to be sent, they are output instead of
EOP. After MCF reception, the sender transmits an image
signal of the second sheet.
If there is an operator call from the sender, it is output
after RTC.
This is output when an operator call is received.
184
DCS
Function
———————