Cordless Base Board - Panasonic KX-FPC135 Service Manual

KX-FPC135 / KX-FPC141
3.5.

CORDLESS BASE BOARD

3.5.1. Preparation
Please prepare the ANALOG BOARD before performing any adjustment procedures. Refer to the ANALOG BOARD REFERENCE
DRAWING for connection and test point locations.
1. Remove the bottom frame of the base unit.
2. Use the telephone cord to connect the fax machine line and PHONE TEST #1 on the telephone analyzer.
3. Use the telephone cord to connect the corded telephone and PHONE TEST #2 on the telephone analyzer.
4. Solder the plus and minus sides of the RF coaxial cable to ANT and RF GND.
5. Connect the BNC connector on the RF coaxial cable to ANT on the Marconi.
3.5.2. Symptom/remedy table
If you have one of the listed symptoms, please refer to this table and make the appropriate adjustments.
3.5.3. Adjustment preparation
Please perform the following steps to prepare the ANALOG BOARD for the Adjustment procedure.
1. Power ON and press MENU and then #, 9, 0, 0, 0, , 9, 5, 8 buttons. ...."TEST MODE"
[Cordless Test] appears on the machine´s LCD display.
2. Press the KEY four times.
[4. Talk Mode] now appears on the machine´s LCD display.
3. Press the START/COPY/SET KEY.
[Channel=01] now appears on the machine´s LCD display.
*Any channel can now be keyed in using the 10 numeric keys on the machine.
4. Press the START/COPY/SET KEY twice.
The talk mode is now established for the channel displayed in step 3.
5. Establish the standard settings of the Marconi.
124