Table of Contents
Advertisement
Operating the built-in
answering device
Operating the answering device
from a remote location
Preparation: Setting the remote operation ID
機能/
1. Press
(Function/Set).
決定
2. Press
機能/
3. Press
(Function/Set).
決定
4. Enter any 4-digit number (remote operation ID) except
or #.
機能/
5. Press
(Function/Set).
決定
6. Press
(Stop).
Operation: Listening to a recorded message from a
remote location
Turn the
(Auto answer) light on before you go out. Remote
operations are available only from a touch tone telephone.
1. Call your unit.
2. Enter the remote operation ID during the greeting message.
3. Press
or wait 4 seconds.
4
Only the new recorded messages will be played back.
To listen to all the recorded messages, press
the new messages have been played back.
Setting the unit to automatically answer incoming calls to
enable you to check the caller's voice when you are at home
You can set the unit so that when you receive an
incoming call, you can check the caller's voice emitted
from the speakerphone of the main unit.
This function operates when
You can answer the telephone after checking the
caller's voice.
When you do not wish to answer the telephone, either
press
or wait for about 30 seconds, and the
connection will be broken.
When using number display, the above function will
not operate if you receive a call from a party who is
registered in the phonebook inside the main unit.
22
.
Example:
留守電暗証番号
1234
is unlit.
Night mode
Turn on the night mode
Press
"
"
When a call is received during night mode, the unit
light on
will handle the call silently, either by storing the
received fax into memory or by recording the caller's
message.
Night mode allows you to select a block of time
during which the unit will not ring for outside calls
or make sounds when you change the settings.
This feature is useful when you do not want to be
disturbed, for example, while sleeping.
Listening to recorded messages
When new messages are recorded, the following will be
displayed.
To listen to the messages, see "Listening to the newly
recorded messages" on page 21.
Printing received fax documents
When new faxes are received,
print indicator) will light on.
To print the faxes, see "Printing a specific fax stored in
memory" on page 19.
Turn off the night mode
Press
after
5
1
Press
2
Press
(Function/Set).
3
Press
then press
4
Press
and then press
5
Press
(Night mode) for about 3 seconds.
is displayed and
lights on.
(Night mode) for about 3 seconds.
機能/
(Function/Set).
決定
, and then press
(Search button) to select " あり ",
機能/
(Function/Set).
決定
to select the number of rings,
機能/
(Function/Set).
決定
(Stop).
新しい用件が
録音されました
(Caller ID log/Fax
機能/
決定
Advertisement
Table of Contents
