Section (For Kx-Fpc141); Atas (Automatic Telephone Answering System); Its (Integrated Telephone System) And Monitor Section (For Kx-Fpc141) - Panasonic KX-FPC135 Service Manual

KX-FPC135 / KX-FPC141
7.10. ITS (Integrated telephone System) and MONITOR SECTION (for KX-
FPC141)
7.10.1. GENERAL
The general ITS operation is performed by the special IC505 which has a handset circuit. The alarm tone, the key tone, and the
beep are output from the ASIC IC501 (digital board). During the pulse dial operation, the monitor tone is output from the ASIC
IC501.
7.10.2. SPEAKER PHONE CIRCUIT
1. Function
The circuit controls the automatic switching of the transmitted and received signals, to and from the telephone line, when the
unit is used in the hands-free mode.
2. Circuit Operation
The speakerphone can only provide duplex.
3. Signal path
Refer to 2.3.3.5. Analog Board Section.
7.10.3. HANDSET CIRCUIT (CORDLESS)
1. Function
This circuit controls the conversation over the handset, i.e. the transmitted and received voices to and from the handset.
2. Signal path
Refer to 2.3.3.5. Analog Board Section.
7.10.4. MONITOR CIRCUIT FOR EACH SIGNALS
1. Function
This circuit monitors various tones, such as 1 DTMF tone, 2 Alarm/Beep/Key tone/Bell 3 Dummy ring back tone.
2. Signal path
Refer to 2.3.3.5. Analog Board Section.
7.11. ATAS (Automatic Telephone Answering System) SECTION
1. Function
The ATAS main operation is performed by the special IC505 (MODEM). IC510 (FLASH MEMORY)´s control signals are input
from ASIC IC501.
a. Greeting/Message Recording
b. ICM Recording
c. Greeting/Message/ICM play to speaker
d. Greeting/Message/ICM play to Tel Line
e. Vox Detection
2. Signal Path
Refer to 2.3.3.5. Analog Board Section.
194