Panasonic KX-FPC135 Service Manual page 56

KX-FPC135 / KX-FPC141
(Cause C)
This model is FAX1 and the other party is FAX2.
For transmission from this model to FAX2, FAX2 executes automatic reception and transmits a CED signal (2100 Hz) followed
by a DIS signal. As the echo cancelers stops as described in cause B, the echo of the DIS signal returns to FAX2. On the other
hand, this model detects the DIS signal and transmits a DCS signal. In other words, it is possible that the echo of the DIS signal
and the DCS signal transmitted from this model reach FAX2 one after the other. FAX2 detects an error and communication
does not start.
(Countermeasure C)
When the international DIS detection setting is set in the service mode (code No.594), this model does not respond to the first
DIS signal and returns a DCS signal only for the second DIS signal.
In other words, there is an interval of 250 msec between transmission of the first and second DIS signal so that the echo
cancelers operation recovers. An echo is not generated for the second DIS signal.
Note:
When the other FAX does not respond with a DCS signal after DIS signal transmission, the DIS signal is transmitted three
times for trial.
Summary:
SYMPTOM
Does not receive in the automatic mode.
Does not transmit.
Does not receive.
6. The unit can copy, but the transmission and reception image are incorrect.
(Long distance or international communication operation)
This symptom highly depends on the transmission and reception capability of the other FAX unit and the line conditions.
The countermeasures for this unit are shown below.
Transmission Operation:
Set the transmitting speed to 4800BPS (service mode: code No. 717) or select the overseas mode.
Reception Operation:
If 80% or more of the reception is incorrect, set the receiving speed to 4800BPS. (Service mode: code No. 718)
• • Refer to 2.4.4. SERVICE FUNCTION TABLE.
Symptom/Countermeasure Table (Long distance and international communication operations)
COUNTERMEASURE
a. If possible, manual transmission should be done from the
transmission side.
b. If possible, two pauses should be inserted at the end of
the auto dial number on the transmission side.
c. If possible, the Function Selector Switch should be
switched to FAX.
a. Confirm the international line mode is ON. (Service mode:
code No. 521)
b. Set the international DIS detection. (Service mode: code
No. 594)
a. Set the time between the CED signal and the DIS signal to
500 msec. (Service mode: code No. 593)
b. Set the CED frequency to 1100Hz. (Service mode: code
No. 520)
56