Panasonic KX-FPC135 Service Manual page 29

1.15.2.1. MAINTENANCE LIST
NO. OPERATION
1 Document Path
2 Rollers
3 Platen Roller
4 Thermal Head
5 Glass, White Plate
6 Sensors
7 Mirrors and Lens
8 Abnormal, wear and tear
or loose parts
1.15.2.2. MAINTENANCE CYCLE
No. Item
1 Separation Roller (Ref. No. 173)
2 Separation Rubber (Ref. No. 44)
3 Feed Rollers (Ref. No. 109)
4 Thermal Head (Ref. No. 51)
5 Platen Roller (Ref. No. 102)
6 Pickup Roller (Ref. No. 134)
* These values are standard and may vary depending on usage conditions.
CHECK
Remove any foreign matter such as paper.
If the roller is dirty, clean it with a damp cloth then dry thoroughly.
If the platen is dirty, clean it with a damp cloth then dry thoroughly.
Remove the paper and film cartridge before cleaning.
If the thermal head is dirty, clean the printing surface with a cloth
moistened with denatured alcohol (alcohol without water), then dry
thoroughly.
If the glass and the white plate are dirty, clean them with a dry soft cloth.
Document sensor (PS302), Read position sensor (PS301), Paper top
sensor (PI402), Film end sensor (PI403), Cover open sensor (PS303) and
Paper set switch (SW101). Confirm the operation of the sensors.
If the mirrors and lens are dirty, clean them with a soft dry cloth.
Replace the part. Check if the screws are tight on all parts.
Cleaning
Cycle Procedure
3 months See 1.15.3.
MAINTENANCE.
3 months See 1.15.3.
MAINTENANCE.
3 months See 1.15.3.
MAINTENANCE.
3 months See 1.15.3.
MAINTENANCE.
3 months See 4. DISASSEMBLY
INSTRUCTIONS.
3 months See 4. DISASSEMBLY
INSTRUCTIONS.
Replacement
Cycle
7 years*
(100,000 documents)
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
7 years (100,000 documents) See 4. DISASSEMBLY
29
KX-FPC135 / KX-FPC141
REMARKS
—
See 1.15.3. MAINTENANCE.
—
See 1.15.3. MAINTENANCE
and 4. DISASSEMBLY
INSTRUCTIONS.
See 1.15.3. MAINTENANCE
and 4. DISASSEMBLY
INSTRUCTIONS.
See 1.15.2. MAINTENANCE
CHECK ITEMS/COMPONENT
LOCATIONS or 2.3.3.9.
Sensor Board Section and
6.5. SENSORS AND
SWITCHES.
—
—
Procedure
See 4. DISASSEMBLY
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.
INSTRUCTIONS.