Foscam FI981W User Manual page 48

Step 1: Open the IP Camera Tool, select the camera you would like to change the port of, right click on the IP address,
and click on "Network Configuration", this brings up the network configuration box as shown in Figure 4.34 and 4.35.
Step 2: Enter the username and password of the Administrator (default username is admin with a blank password), and
click "OK" to apply changes.
Step 3: Wait around 10 seconds, you'll see that the camera's LAN IP address has changed. In our example it was
changed to 2000, so we see http://192.168.8.102:2000 in IP Camera Tool. Also, the LAN IP address is now fixed at a
static IP address of http://192.168.8.102:2000. This IP address will not change even if the camera is powered off and
back on, the camera will remain on this LAN IP address. This is very important that a static LAN IP address is set, or
you may have problems later with remote access and seeing the camera remotely if the camera loses power and
reconnects on a different LAN IP address. Make sure you set a static LAN IP address!
Shenzhen Shenzhen Foscam Foscam Intelligent Intelligent
Tel: Tel: 86 86 755 755 2674 2674 5668 5668 Fax: Fax:
Figure 4.34
Technology Technology Co., Co., Limited Limited
86 86 755 755 2674 2674 5168 5168
Figure 4.35
www .foscam.com
www .foscam.com
45