Battery Installation; Head Unit - Vetta V100 User Manual

BATTERY INSTALLATION

HEAD UNIT

The V100 head unit uses a CR2032 3V lithium button cell battery.
IMPORTANT: Most cycle computer problems are caused by
weak or dead batteries. See the Troubleshooting section near
the end of this manual for details.
Remove the battery cover from the bottom of the
Step 1:
computer using a coin. Remove the old battery.
Step 2: Install a new battery as shown with the positive (+) side
facing out. Do not touch or bend any of the battery
contacts during installation.
Screw the battery cap firmly into place making sure the
Step 3:
o-ring seal does not get pinched or distorted.
CAUTION: To avoid damage to the battery cap, do not over
tighten.