HIKVISION DS-8104HMI-A User Manual page 42

You can use [PTZ] key to set the whole screen as motion area, and multi motion areas can be
defined. Press [A]key to clear all motion areas. The minimum area is one panel. After you setup
the areas, press [ENTER] key to return "Image Setup" menu.
The keys used to setup motion areas are following:
 Move yellow pane to any position:[ ],[ ],[ ],[ ];
 Yellow pane and red pane switch key:[EDIT];
 Yellow pane and black pane switch key:[EDIT];
Left shrink red pane:[ ];

Right enlarge red pane:[ ];

Down enlarge red pane:[ ];

Up shrink red pane:[ ];

Set whole screen as motion area:[PTZ];

Clear all motion areas:[A];

Save and return "Image Setup" menu:[ENTER];

Cancel setup and return "Image Setup" menu:[ESC]

Motion alarm policy (Fig.5.16):
1. Motion alarm schedule:
You can setup it in "Motion Det."—>"Policy" menu. The setup steps are the same as external alarm in schedule, please refer to section 5.3.1.
2. Alarm linkage setup:
The alarm linkage setup includes recording, handle method, etc. All the linkages can be set in "Policy" menu. (Fig.5.16) The linkage order of motion detection is
Alarm in  Trigger camera  Recording. (Record setup please refer to section 5.4)The alarm handle method includes on screen warning, audible warning, upload
to center, trigger alarm out.
Note: If you want to disable motion alarm area and motion alarm policy, you just need to select the motion alarm sensitivity as "Off".
User Manual of DS-8104HMI-A(/XX) Series Mobile Net DVR (V1.20.00)
41
Fig.5.16 Motion Alarm Handle