Assembly Instructions - Landa SEA3-1100 Operator's Manual

Spray
Gun
Safety
Latch
High Pressure
Hose
STEP 1: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 4: Connect garden hose to
the cold water source.

ASSEMBLY INSTRUCTIONS

STEP 2: Insert nozzle into coupler.
Outlet Fitting
STEP 5: Connect the high pressure hose to the outlet
discharge fitting. Push coupler collar forward until se-
cure. Connect the garden hose to pump water inlet.
Inspect inlets. CAUTION: Do not run the pump with-
out water or pump damage will result.
LANDA SEA • 96-722 • REV. 11/05
Nozzle
Coupler
STEP 3: Release the coupler col-
lar and push the nozzle until the
collar clicks. Pull the nozzle to make
sure it is seated properly.
7