Assembly Instructions - Landa PE Operator's Manual

Safety
Latch
High Pressure
Hose
STEP 1: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 4: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick or observe
oil level in oil window (if equipped).
Use 30 wt. (non detergent) oil.
Pump
Water Inlet
STEP 7: Check inlet filters, re-
move debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
6

ASSEMBLY INSTRUCTIONS

Spray
Gun
STEP 2: Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
DipStick
Coupler Collar
STEP 5: Connect the high pres-
sure hose to the pump discharge
fitting. Push coupler collar forward
until secure.
Garden
Hose
LANDA PE 8.913-998.0
Pressure
Nozzle
Wand
Coupler
Pump
Discharge
Fitting
High
Pressure
Hose
Pressure
Nozzle
Wand
Coupler
Coupler
Collar
STEP 3: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Cold
Water
Source
Garden
Hose
STEP 6: Connect garden hose to
the cold water source.