Page 1
® WATER CLEANING SYSTEMS OPERATOR’S MANUAL ■ ■ ■ SEA3-1100 SEA4-2000 SEA4-3000 ® For technical assistance or the dealer nearest you consult our web page at www.landa.com or call 360-833-1600 96-722...
The model and serial numbers will be found on a decal attached to the pressure washer. You should record both serial number and date of purchase and keep in a safe place for future reference. LANDA SEA • 96-722 • REV. 11/05...
RISK OF EXPLOSION: 5. Risk of explosion — do not DO NOT USE WITH Landa, Inc. reserves the right to make changes at any FLAMMABLE spray flammable liquids or op- LIQUIDS. time without incurring any obligation.
Page 5
16. The best insurance against an accident is precau- the manual. tion and knowledge of the machine. 17. LANDA will not be liable for any changes made to our standard machines or any components not pur- chased from LANDA .
2 minutes, water will leak from valve. Warm detergent onto cleaning surface with trigger device. In- water will discharge from pump protector onto floor. cludes safety latch. This system prevents internal pump damage. LANDA SEA • 96-722 • REV. 11/05...
Push coupler collar forward until se- cure. Connect the garden hose to pump water inlet. Inspect inlets. CAUTION: Do not run the pump with- out water or pump damage will result. LANDA SEA • 96-722 • REV. 11/05...
Note: High pressure nozzle must safety latch on the spray gun trig- be inserted at end of wand to obtain high pressure. To ger. apply soap read operator's manual. LANDA SEA • 96-722 • REV. 11/05...
If you run the engine on your pressure washer for 3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach high tempera- LANDA SEA • 96-722 • REV. 11/05...
2. Restart pressure washer and let it run briefly (about 5 seconds) until water no longer discharges from the high pressure outlet. LANDA SEA • 96-722 • REV. 11/05...
Broken or weak suction or delivery Check and replace if necessary. valve spring Foreign matter in valves Check and clean if necessary. Worn bearings Check and replace if necessary. Excessive temperature of water Reduce to below 140 LANDA SEA • 96-722 • REV. 11/05...
Replace coil after the timer and unloader switch have been tested. Timer is defective Join wires 15 and 16 together on timer. If MACHINE WILL NOT TURN ON WHEN machine works, replace timer. SWITCH IS PUSHED LANDA SEA • 96-722 • REV. 11/05...
Check pump oil level before first use. Change pump oil after first 50 hours and every month or 500 hours thereaf- ter. Use SAE 30 weight oil. Estimated Operating Estimated Operating Date Oil Changed Hours Since Last Date Oil Changed Hours Since Last Month/Day/Year Oil Change Month/Day/Year Oil Change LANDA SEA • 96-722 • REV. 11/05...
Page 27
LANDA Dealers, to make any representation or promise on behalf of LANDA, or to modify the terms, conditions, or limitations in any way. It is the buyer’s responsibility to ensure that the installation and use of LANDA products conforms to local codes.
Page 28
® WATER CLEANING SYSTEMS Form #96-722 • Revised 11/05 • Printed in U.S.A.