Page 1
SDHW Military Model Hot Water - Skid Mounted-Diesel-Powered - Diesel/Oil-Heated Operator’s Manual Pressure Washer MODELS: SDHW6-35824E/M (Black) 1.110-516.0 SDHW6-35824E/MT (Tan) 1.110-560.0 For the Landa Dealer nearest you, consult our web page at www.landa.com 8.913-958.0-AC 01/26/23...
It also stream at people or severe injury or death will contains chemicals known, in certain quantities, to result. cause cancer, birth defects, or other reproductive harm. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
Page 5
14. Landa will not be liable for any changes made to 27. Do not overreach or stand on unstable support. our standard machines, or any components not Keep good footing and balance at all times.
45 degree bends and go the next size pipe. The overall pipe length must not exceed 6 feet in length. 10. These machines are intended to be protected from the outside environment. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
5-10 minutes. After washing, rinse from the top down. 3. Cleaning heavy dirt or material away with a hard stream of clear water is recommended before using a cleaning agent. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
Page 9
5 minutes sans eau. Débrancher tous les boyaux pour permettre l'évacuation de l'eau. Avec la machine hors tension, ouvrir le pistolet pulvérisateur pour relâcher la pression avant de retirer le tuyau de refoulement. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
Oil equipment clean and dry. should be maintained at that level. The area around the Landa washer should be kept Cleaning of Coils clean and free of combustible materials, gasoline and other flammable vapors and liquids.
This can be done by operating the machine and checking to see that when the spray gun is in the off position, the burner is not firing. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
Tighten locking screws. needs with air band and fuel pressure settings alone. NOTE: When changing fuel pump, a by-pass plug must be installed in return line port or fuel pump will not prime. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
5. Remove the three 3/8" bolts from each side of coil and tank assembly (these bolts are used to fasten Coil Reinstallation tank to chassis). 11. Reinstall new or cleaned coil reversing Steps 9 through 1. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
Thermostat faulty or slow engine speed Increase engine RPM to increase voltage. Remove, test for continuity and replace as Flow switch malfunction needed. Fuel solenoid malfunction Replace if needed. (For parts and information, call your Landa Dealer) Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
Page 15
Incorrect fuel nozzle size See breakdown for model. Insufficient water supplied Check water G.P.M. to machine. Restricted water flow Check serial plate for proper size. (For parts and information call your Local Dealer) Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
Page 16
High viscosity of detergent Dilute detergent to specifications. Hole in detergent line(s) Repair hole. Low detergent level Add detergent if needed. Relief Valve Leaks Relief valve defective Replace or repair. Water Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
KIT INSTRUCTIONS which came with the kit. It contains replacement parts numbers needed for ordering future parts. NOTE: The manual part number is located on the lower right corner of the front cover. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...
SDHW6-35824E/MT, SDHW6-35824E/M washer. All information in this manual is based on the latest product information available at the time of printing. Landa, Inc. reserves the right to make changes at any time without incurring any obligation. Owner/User Responsibility: The owner and/or user must have an understanding of the manufacturer’s operating instructions and warnings...
Landa SDHW Right To Water Filled Pillow Tank To Control Panel 53, 161, 114 53 54 Detail See Float Box Illus. Detail See Control Panel Illus. Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC...