Table of Contents
Advertisement
Troubleshooting
Troubleshooting
In which way does a new device (GigE camera) get its IP
address in the network?
The following flowchart shows the way to access a new device in the network
(implemented by AVT):
1. Persistent IP (factory default: disabled)
2. DHCP (if enabled; factory default: enabled)
3. Link-Local Address (APIPA or Auto IP) (always enabled)
Note
Link-Local Address is abbreviated commonly with LLA.
Other terms are: APIPA or Auto IP
Begin
Yes
Is Persistent IP
Use Persistent IP
Configured?
No
Is DHCP
Yes
enabled?
(4 attempts, ca.
14 seconds)
No
Use Link-Local
Address
End
Figure 34: IP address allocation flowchart
(unique)
Use DHCP
assigned?
Manta Hardware Installation Guide V4.1.0
Yes
Was IP
address
No
54
Advertisement
Table of Contents
