Table of Contents
Advertisement
Camera interfaces
Camera interfaces
Each AVT Manta camera has the following interfaces:
•
The 12-pin camera I/O connector provides different control inputs and
output lines and external power (via external power supply).
•
One GigE connector with screw lock mechanism provides access to the
GigE network and thus makes it possible to control the camera and out-
put frames. For cameras that are PoE capable, the GigE connector can be
used to provide power to the camera.
Note
For information on status LEDs see Chapter
(MANTA)
Note
• If you supply power via PoE, the power must comply
with IEEE 802.3at.
• If both interfaces are used for power (I/O and GigE
connector via PoE), the camera will only use the power
from the I/O connector.
How can I distinguish between PoE capable cameras and
cameras that are not PoE capable?
• PoE capable cameras have the letters PoE written on
the camera's label on the back side and the bottom side
of the camera.
• PoE capable cameras have the GigE jack upside down.
Exception
Manta G-145-30fps and Manta G-201-30fps (non PoE):
• ... have same I/O pin assignment (input circuits and
voltage range), power LED and upside down PoE plug as
PoE models.
on page 45.
Manta Hardware Installation Guide V4.1.0
Status LEDs
43
Advertisement
Table of Contents
