Table of Contents
Advertisement
AVT Manta cameras: installing hardware and software
Overview hardware installation
Installing Gigabit Ethernet network card
•
Install Gigabit Ethernet network card (recommended: a second network
card for your PC) and configure network card (Jumbo Frames, Receive
Descriptors, Performance Options and IP address settings).
•
Install software (AVT Universal Package incl. viewer application or
AVT PvAPI SDK plus corresponding viewer application) and start the
viewer:
see AVT Universal Package User Guide or Chapter
Viewer application and configure IP settings
•
Connect camera to PC or laptop and ensure that the camera is powered.
– If you are supplying power via PoE, the power provided must comply
with IEEE 802.3at.
Note
Read the software manual (AVT Universal Package User
Guide/AVT PvAPI Programmer's Reference Manual) to get
information on acquiring your first image with UniCam or
GigE sample viewer and troubleshooting.
www
Documentation of AVT Universal Package or
AVT PvAPI SDK:
http://www.alliedvisiontec.com/emea/support/downloads/
software.html
For GigE sample viewer see Chapter
Viewer
on page 37.
Note
Use a recommended network card listed in Chapter
conditions
The following steps describe the installation of an Intel PRO/
1000 GT network card in your host computer. For other net-
work cards, the steps required are almost the same.
Notes are included for other (non-Intel) network cards where
there is likely to be a difference.
Read also the documentation from your network card manu-
facturer before installing the network card.
on page 24.
Manta Hardware Installation Guide V4.1.0
Start GigE Sample
on page 35
Using the GigE Sample
Hardware
26
Advertisement
Table of Contents
