Table of Contents
Advertisement
AVT Manta cameras: installing hardware and software
Connecting camera to PC or laptop
Start AVT UniCam Viewer application and
configure IP settings
Caution
• Use only DC power supplies with insulated power
pins. These are identified by having only two power
connectors.
1. Insert one end of the CAT-5e (or better) Ethernet cable into your Gigabit
Ethernet network card.
2. Insert the other end of the CAT-5e (or better) Ethernet cable into your
GigE camera.
3. Connect the external power supply to the GigE camera and check that
the camera is powered.
– You can power the camera via I/O connector or
– You can power the camera via PoE (must comply with IEEE 802.3at).
Note
The following description refers to the AVT Universal
Package with AVT UniCam Viewer.
For description of GigE sample viewer see Chapter
GigE Sample Viewer
1. Start the AVT UniCam viewer: Start All Programs Allied Vision
Technologies Universal Package AVT UniCam Viewer
Your GigE camera should appear in the list of cameras in the viewer
application. This may take a few seconds.
Note
It may take some time for your GigE camera to be recognized
by the host computer.
• If your GigE camera doesn't appear in the viewer appli-
cation's list after 1 minute, reset your GigE camera by
disconnecting and re-connecting the power.
• If it still doesn't appear, restart the viewer application.
• If it still doesn't appear, read Chapter
on page 54ff.
2. Optional: Configure IP settings manually: Again double-click the net-
work connection corresponding to the network card that was just
installed. In the list of items select Internet Protocol (TCP/IP) and
on page 37.
Troubleshooting
Manta Hardware Installation Guide V4.1.0
Using the
33
Advertisement
Table of Contents
