Safety Instructions For Board Level Cameras - AVT Manta Installation Manual

Safety instructions

Safety instructions for board level cameras

Note Read the Manta Technical Manual and this safety
instructions before use.

Abuse or misapplication of the camera may result in
limited warranty or cancelation of warranty.
Caution-ESD Board level cameras: ESD warnings
• Only qualified personnel is allowed to install and
operate the board level cameras.
• Board level cameras are delivered without housing.
Handle the sensor board and main board with care. Do
not bend the boards. Do not touch the components or
contacts on a board. Hold a board by its edges.
• Sensor board and main board are sensitive to
electrostatic discharge. To avoid possible damage,
handle all static-sensitive boards and components in a
static-safe work area. Follow the procedures below.
• ESD (electrostatic discharge): Static electricity can
damage the sensor board or the main board of your
Board level cameras. To prevent static damage,
discharge static electricity from your body before you
touch any of your Board level cameras's electronic
components, such as sensor board or main board. To do
so, use a static-safe work area with static-dissipative
mat and wear a static-dissipative wrist strap. Do not
hold any components of your Board level cameras
against your clothing. Even if you are wearing a wrist
strap, your body is grounded but your clothes are not.
• Do not remove the sensor board and main board from its
anti-static packaging unless your body is grounded.
• ESD shielding: To protect the boards from radiation of
other modules or devices use a special ESD protective
housing.
Manta Hardware Installation Guide V4.1.0
16