Configuration Parameter Types - GE 90*-30 PLC Series User Manual

C
Module Control %Q
locations
Parameter 0 definition
Config File/Init File
definition
Hand Held Programmer
Dependent parameters
Configuration Freeze
Packing of Discrete NVs
into %I, %Q

Configuration Parameter Types

C-4
Table C-5. - Continued
8 bits of %Q register (mapped to first location).
Bit 1: Reset Module (hardware reset)
Bit 2: Send Service Pin Message
Bits 3-8: reserved for future use.
Created from Network Variable Definition File (.XIF) file.
Created from Network Variable Definition File (.XIF) file.
By setting the maximum parameter to 1, and parameter 1 to the text "Last Parameter", the API will
handle all commands from the Hand Held Programmer attached to the PLC CPU
None (API skip table not used).
Not Used
SNVT_lev_disc, SNVT_switch supported.
Standard Configuration Parameter Types (SCPTs) are used to transfer node configuration
information via the L T
ON
amounts of configuration information on a node. SCPTs do not use network variable resources
and are downloaded and uploaded to a node via the L
Series 90™-30 PLC LONWORKS® Bus Interface Module User's Manual – June 1997
File Transfer protocol. SCPTs provide a means of handling large
ALK
T file transfer protocol.
ON ALK
GFK-1322A