GE 90*-30 PLC Series User Manual page 5

Content of this Manual
GFK-1322A
This manual describes the features and operation of the Series 90™ PLC L
Interface Module (PE693BEM350, 351, and 352). It also provides the configuration and
programming information needed to complete the interface between a Series 90-30 programmable
logic controller (PLC) and a L
Chapter 1. Module Overview: Provides overviews of the L
(LBIM) and the Echelon
Chapter 2. Operation: Describes the operation of the LBIM.
Chapter 3. Hardware Installation: Explains how to install an LBIM in a Series 90 rack.
Provides recommendations for connecting an LBIM node to a L
Chapter 4. Configuration: Explains how to configure the module network interface and set
configuration parameters. Describes network binding.
Chapter 5. Troubleshooting: Lists problem symptoms and corrective actions. Describes the use
of Valid bits for network variables.
Appendix A. Specifications: Lists physical specifications and electrical and environmental
requirements.
Appendix B: Standard Network Variable Types: Lists the Standard Network Variable Types
supported by the LBIM as of the time this manual was published. (Refer to the most recent version
of The SNVT Master List and Programmer's Guide — 005-0027-01 — for a current listing.)
Appendix C. Configuration File Specifications: Contains reference information pertaining to
the files that are created by the configuration software.
Appendix D. Glossary: Provides definitions of acronyms and terminology.
Appendix Q. Quick Start Guide. Describes the steps necessary to get your LBIM up and running
quickly. To use this guide, you should have a working knowledge of L
technology and GE Series 90-30 PLCs.
®
Echelon, Neuron, L
ON
™ Logicmaster and Series 90 are trademarks of GE corporation.
W network.
ON ORKS
®
L W network.
ON ORKS
T , and L W are registered trademarks of Echelon Corporation.
ALK ON ORKS
Preface
W
ON ORKS
W Bus Interface Module
ON ORKS
W network.
ON ORKS
W network
ON ORKS
®®
Bus
v