Advertisement
Regulatory & Other Information
© 2006 Digi, Digi International, the Digi logo, the
Digi Connectware logo, Rapidport, Edgeport,
and Hubport are either trademarks or registered
trademarks of Digi International, Inc. in the United
States and/or other countries. All other trademarks
are the property of their respective holders.
Information in this documentation is subject to
change without notice and does not represent a
commitment on the part of Digi International
Digi International provides this document ―as is,‖
without warranty of any kind, either expressed or
implied, including, but not limited to, the particular
purpose.
Digi
International
improvements
and/or
documentation or
to the product(s) and/or
program(s) described in this documentation at any
time.
Digi International assumes no responsibility of any
errors, technical inaccuracies, or typographical
errors that may appear in this documentation, nor
liability for any damages arising out of its use.
Changes are made periodically to the information
herein; these changes may be incorporated in new
editions of the publication.
For U.S. Government use:
Any provision of this document and associated
computer programs to the U.S. Government is with
―Restricted Rights.‖ Use, duplication, or disclosure
by the government is subject to the restrictions set
forth in, subparagraph (c) (1) (ii) of the Rights in
Technical Data and Computer Software clause of
DFARS 52.277-7013.
For non-U.S. Government use:
These programs are supplied under a license. They
may be used, disclosed, and/or copied only as
supplied under such license agreement. Any copy
must contain the above copyright notice and
restricted rights notice. Use, copying, and/or
disclosure of the programs is strictly prohibited
unless otherwise provided for in the license
agreement.
Federal Communications Commission
(FCC) Regulatory Information (USA only)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
Rapidport Installation Guide (90000665 Rev. C) – Page 10
may
make
changes
to
this
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and the receiver.
Connect the equipment into an outlet that
is on a circuit different from the receiver.
Consult the dealer or an experienced
radio/TV technician for help.
Warning: The connection of a non-shielded
interface cable to this equipment will invalidate the
FCC Certification for this device.
FCC Regulation - Part 15
Declaration of Conformity (DoC)
This device complies with the requirements of the
Code of Federal Regulations listed below:
FCC Title 47 CFR, Part 15 Class B for a digital
device.
Operation is subject to the following two
conditions:
This device may not cause harmful interference,
and
This device must accept any interference received,
including interference that may cause undesired
operation.
Department of Communication (DOC)
Notice (Canada only)
This Class B digital apparatus meets the
requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe B respecte
toutes les exigences du Règlement sur le matériel
brouiller du Canada.
Advertisement
