Shutdown Procedures; Storage - Landa EHW4-2000C Operator's Manual

Toggle
Switch
IO N ica ls
em il)
U T e ch ne ,o
C A siv as oli
rro er ,g
r co th inn
ot he
an d pa int
uc ts (i. e.
: pr od nt s th e
e so lve od uc ts ag e
Us lor ine da m
ve r , ch ing e pr wi ll
Ne ea ch nt ain ph at an d
• Bl s co ph os un it
uid od uc ts th e
• Liq ium uc ts
i-s od ia pr pr od ll ha rm
• Tr m on se d ls wi
• Am an ed .
id- ba ica
• Ac ch em cle
es e be ing
Th ce
su rfa
STEP 1: Rinse all lines (and
injector) with clean water, to remove
any soap residue then turn toggle
switch off.
Pump Storage
CAUTION: Always store your pres-
sure washer in a location where the
temperature will not fall below 32° F
(0° C). The pump in this machine is
susceptible to permanent damage
CAUTION
if frozen.
F R E E Z E DA M AG E I S N OT C OV E R E D B Y
WARRANTY.
If you must store your pressure washer in a location
where the temperature is below 32° F, you can minimize
the chance of damage to your machine by draining your
machine as follows:
1. Stop the pressure washer and detach supply hose
and high pressure hose. Squeeze the trigger of the
spray gun to drain all water from the wand and
hose.
2. Restart pressure washer and let it run briefly (about
5 seconds) until water no longer discharges from
the high pressure outlet.
10

SHUTDOWN PROCEDURES

STEP 2: Turn off water supply.

STORAGE

8.941-114.0 • LANDA EHW • Rev. 08/12
STEP 3: Open spray gun to relieve
remaining pressure and remove
water supply hose.
In freezing conditions, disconnect
water supply and open spray gun
to allow water to drain, then turn
off motor.
CAUTION: Do not allow pump to
run longer than 5 minutes without
water. Disconnect all hoses to
allow water to drain.
CAUTION: With machine off, open
spray gun to release pressure be-
fore removing discharge hose.