Shutdown Procedures; Storage; Pump Storage - Landa EHW Series Operator's Manual

Operations

Shutdown Procedures

Toggle
Switch
ls
IO N ica
U T e ch em ne ,o il)
as oli
C A rro siv
r co er ,g
ot he th inn
an d pa int
uc ts (i. e. th e
: pr od nt s ag e
e so lve od uc ts ua l
ve r Us lor ine da m
, ch ing e pr wi ll m an
Ne ea ch nt ain ph at an d d in
• Bl s co ph os un it en de
uid od uc ts th e
• Liq ium uc ts m m
i-s od ia pr pr od ll ha rm re co
• Tr m on ts as
se d ls wi .
• Am id- ba ica an ed rg en
• Ac ch em cle de te
es e be ing re r's
ac tu
Th ce an uf
su rfa
e m
Us
STEP 1: Rinse all lines (and
injector) with clean water, to
remove any soap residue then turn
toggle switch off.

Storage

Pump Storage

CAUTION: Always store your
pressure washer in a location where
the temperature will not fall below
32° F (0° C). The pump in this
machine is susceptible to
CAUTION
permanent damage if frozen.
FREEZE DAMAGE IS NOT COVERED BY
WARRANTY.
If you must store your pressure washer in a location
where the temperature is below 32° F, you can
minimize the chance of damage to your machine by
draining your machine as follows:
14
STEP 2: Turn off water supply.
1. Stop the pressure washer and detach supply hose
2. Restart pressure washer and let it run briefly (about
Landa EHW Operator's Manual 8.941-114.0 - M
STEP 3: Open spray gun to relieve
remaining pressure and remove
water supply hose.
In freezing conditions, disconnect
water supply and open spray gun to
allow water to drain, then turn off
motor.
CAUTION: Do not allow pump to
run longer than 5 minutes
without water. Disconnect all
hoses to allow water to drain.
CAUTION: With machine off,
open spray gun to release
pressure before removing
discharge hose.
and high pressure hose. Squeeze the trigger of the
spray gun to drain all water from the wand and
hose.
5 seconds) until water no longer discharges from
the high pressure outlet.