Shutdown Instructions; Storage - Landa PG Series Operator's Manual

STEP 1: Remove detergent suction
tube from container and insert into
one (1) gallon of fresh water. Pull
trigger on spray gun and siphon
water for one minute.
STEP 4: Disconnect all hoses to
allow water to drain. Protect from
freezing.
CAUTION: Always store your pressure washer in a
location where the temperature will not fall below
32°F (0°C). The pump in this machine is susceptible
to permanent damage if frozen. FREEZE DAMAGE
IS NOT COVERED BY WARRANTY.
1. Stop the pressure washer, squeeze spray gun trig-
ger to release pressure.
2. Detach water supply hose and high pressure hose.
3. Turn on the machine for a few seconds, until re-
maining water exits. Turn engine off immediately.
4. Drain the gas and oil from the engine.
5. Do not allow high pressure hose to become kinked.
6. Store the machine and accessories in a room which
does not reach freezing temperatures.
CAUTION: Failure to follow the above directions will
result in damage to your pressure washer.
When the pressure washer is not being operated or is being
stored for more than one month, follow these instructions:
1. Replenish engine oil to upper level.
2. Drain gasoline from fuel tank, fuel line, fuel valve
and carburetor.
3. Pour about one teaspoon of engine oil through
the spark plug hole, pull the starter grip several
times and replace the plug. Then pull the starter
grip slowly until you feel increased pressure which
indicates the piston is on its compression stroke and

SHUTDOWN INSTRUCTIONS

Fuel Lever
Choke Lever
STEP 2: Turn off engine.

STORAGE

LANDA PG 8.913-910.0
STEP 3: Turn off water supply and
disconnect water supply hose from
washer. CAUTION: Do not allow
pump to run without water.
leave it in that position. This closes both the intake
and exhaust valves to prevent rusting of cylinder.
4. Cover the pressure washer and store in a clean, dry
place that is well ventilated away from open flame
or sparks. NOTE: The use of a fuel additive, such
as STA-BIL , or an equivalent, will minimize the
®
formulation of fuel deposits during storage. Such
additives may be added to the gasoline in the fuel
tank of the engine, or to the gasoline in a storage
container.
After Extended Storage
CAUTION: Prior to restarting, thaw out any possible
ice from pressure washer hoses, spray gun or wand.
Engine Maintenance
During the winter months, rare atmospheric con-
ditions may develop which will cause an icing condition
in the carburetor. If this develops, the engine may run
rough, lose power and may stall. This temporary condi-
tion can be overcome by deflecting some of the hot air
from the engine over the carburetor area. NOTE: Refer
to the engine manufacturer's manual for service and
maintenance of the engine.
11