Hot water - diesel powered - diesel/oil heated (44 pages)
Summary of Contents for Landa PGHW4-3000
Page 1
I I I I I PGHW5-3000 I I I I I PGHW5-3500 LANDA, INC. 4275 N.W. Pacific Rim Blvd. Camas, WA 98607 For technical assistance or the Landa Dealer nearest you, call 800-LANDA-4-U (800-526-3248) or (360) 833-9100 or consult our web page at www.landa.com...
5. Avoid installing machines in formation available at the time of printing. small areas or near exhaust Landa, Inc. reserves the right to make changes at any fans. Exhaust contains poison- time without incurring any obligation. RISK OF ous carbon monoxide gas;...
WARNING: Spray gun kicks back. Hold with both 27. Landa will not be liable for any changes made to our hands. standard machines or any components not pur- 11.
Burner will now light automatically. NOTE: Do not start machine with burner switch on. 7. To apply detergent, place detergent pick-up tube into a container of detergent and turn the detergent valve counterclockwise (see page 8). LANDA PGHW • 96-6031 • REV. 7/03...
The flow of combustion and ventilating air to the burner must not be blocked or obstructed in any manner. Deliming Coils: The area around the Landa washer should be kept clean Periodic flushing of coils or optional float tank is recom- and free of combustible materials, gasoline and other mended.
First, check the fuel to be certain that kero- must be installed in return port or fuel pump will not prime. sene or No. 1 home heating fuel is being used. Next, check the air adjustment on the burner. LANDA PGHW • 96-6031 • REV. 7/03...
Reinstall new or cleaned coil reversing Steps 9 through 1. can be obtained, then repeat the above procedure on the air band setting. LANDA PGHW • 96-6031 • REV. 7/03...
PGHW SERIES PRESSURE WASHER OPERATOR’S MANUAL EXPLODED VIEW RIGHT SIDE Detail See Float Tank Illus PGHW4-3000E Detail See Control Panel Illus PGHW 4-3000E LANDA PGHW • 96-6031 • REV. 7/03...
Replace as needed. Disconnected or short in electrical All wire contacts should be clean and tight. (continued on next wiring No breaks in wire. page) For parts or information contact your local LANDA dealer. LANDA PGHW • 96-6031 • REV. 7/03...
Page 25
Misaligned electrode setting Realign electrodes to specifications. Obstruction in smoke stack Check for insulation blockage or other foreign objects. Low engine RPM Increase RPM. For parts or information contact your local LANDA dealer. LANDA PGHW • 96-6031 • REV. 7/03...
Page 26
Cracked piston Check and replace if necessary. Pump protector Lower water supply pressure. Do not run with spray gun closed longer than 2 minutes. For parts or information contact your local LANDA dealer. LANDA PGHW • 96-6031 • REV. 7/03...
Replace switch. Loose wire Check and replace or tighten wiring. Defective burner motor Replace motor. RELIEF VALVE Relief valve defective Replace or repair. LEAKS WATER For parts or information contact your local LANDA dealer. LANDA PGHW • 96-6031 • REV. 7/03...
TICULAR PURPOSE. LANDA does not authorize any other party, including authorized LANDA Dealers, to make any represen- tation or promise on behalf of LANDA, or to modify the terms, conditions, or limitations in any way. It is the buyer’s responsibility to ensure that the installation and use of LANDA products conforms to local codes.
Page 30
® WATER CLEANING SYSTEMS 4275 NW Pacific Rim Blvd. • Camas, WA 98607 USA Form #96-6031 • Revised 7/03 • Printed in U.S.A. by Landa, Inc., Camas, WA 98607...
Need help?
Do you have a question about the PGHW4-3000 and is the answer not in the manual?
Questions and answers