Pre-Operation Check; Set-Up Procedures - Landa ZC3-15321 Operator's Manual

ZC SERIES PRESSURE WASHER
4
WARNING: High pressure spray
WARNING
can cause paint chips or other par-
ticles to become airborne and fly
at high speeds. To avoid personal
injury, eye safety devices must be
worn.
PROTECTIVE
8. Eye safety devices and foot pro-
EYEWEAR AND
CLOTHING MUST
tection must be worn when us-
BE WORN.
ing this equipment.
9. High pressure developed by these machines will
cause personal injury or equipment damage. Use
caution when operating. Do not direct discharge
stream at people, or severe injury or death will re-
sult.
10. Never make adjustments on machine while in op-
eration.
11. Do not operate with spray gun in the off position for
extensive periods of time as this may cause dam-
age to the pump.
12. The best insurance against an accident is precau-
tion and knowledge of the machine.
13. Landa will not be liable for any changes made to our
standard machines, or any components not pur-
chased from Landa.
14. Read engine safety instructions provided.
WARNING: Keep water spray
WARNING
away from electrical wiring or
fatal electric shock may result.
15. Never run pump dry or leave
spray gun closed longer than 5
minutes.
KEEP WATER SPRAY
16. To reduce the risk of injury,
AWAY FROM
close supervision is necessary
ELECTRICAL WIRING.
when a machine is used near
children. Do not allow children to operate the pres-
sure washer. This machine must be attended dur-
ing operation.
17. Inlet water supply must be cold and clean fresh water.

PRE-OPERATION CHECK

❑ Check pump oil level. (Use SAE 30W non-detergent
oil). Dipstick is located on top of pump.
❑ Cold water supply (minimum 6 gpm, 5/8", 20 psi)
❑ Hose, wand, nozzle (nozzle size per serial plate)
❑ Water filter (intact, non restrictive)
❑ Fuel (unleaded 86 or higher octane)
❑ Open spray gun to relieve pressure before starting.
❑ Engine oil (SAE 10W30)
These machines are designed for outdoor use. Ma-
chine must be stored indoors when not in use.

SET-UP PROCEDURES

❑ Attach a 5/8" garden hose to inlet connector. Mini-
mum flow should be 6 gpm.
❑ Attach high pressure hose to discharge nipple using
quick coupler. Lock coupler securely into place by
pulling back coupler collar and inserting it onto dis-
charge nipple, then pushing collar forward to lock in
place. (Also see page 5).
❑ Attach variable pressure wand to spray gun using
teflon tape on threads to prevent leakage.
❑ Attach swivel connector on discharge hose to spray
gun using teflon tape on threads.
❑ Remove oil plug on top of pressure washer pump
and replace with dipstick supplied. (This may be
installed from the factory.)
Dipstick
Sightglass
❑ Check oil level on sight glass on back of pump. Oil
should be visible one half way up sight glass (30W
non-detergent).
❑ Fill gasoline tank and check engine oil.
❑ Notice: Running the engine with a low oil level can
cause engine damage.
LANDA ZC • REV. 5/02
OPERATOR'S MANUAL
Discharge
Nipple
Collar
Filter
Inlet
Connector
Filler Cap/Dipstick
Pressure
Hose
Garden
Hose
Upper Limit
Lower Limit