Re-Setting Function - Zephyr Tempest II AK7500ASX User, Care, And Installation Manual

Baffle Filter Clean Reminder
Whether your hood is installed as an exhaust or purifying unit, a set if baffle filters are fitted by the factory,
These baffle filters are intended to filter out residue from cooking. They need not be replaced on a regular
basis but are required to be kept clean. The filter clean reminder function in the microprocessor will
automatically indicate by a flashing
use. Filters can be cleaned by hand with non-abrasive soap or in a dishwasher. Heavily soiled filters
should also be soaked in grease cutting detergent prior to cleaning.
Baffle Filter Clean Indicator
F
When flashes on display, the baffle filters
installed are required to be cleaned. This will occur
after every 30 hours of use.

Re-setting Function

Reset the filter clean reminder timer when filters are
cleaned and re-installed (with hood off). Press and
hold for approximately 5 seconds, the display will
appear; hold for approximately 5 seconds until
display disappears . The filter clean reminder
function is now reset and a new 30 hours elapse
cycle is initiated.
F
when the baffle filters need to be cleaned after every 30 hours of
F on

Clean Filters
display < F > flashes
F
To Reset
hold 5 sec. display from < F > to < >
F