Solid State Speed Controller - Club Car XRT 800 Maintenance Service Manual

ELECTRICAL COMPONENTS: ELECTRIC VEHICLE

SOLID STATE SPEED CONTROLLER

See General Warning on page 1-1.
Testing the Solid State Speed Controller
See Test Procedure 5, Section 21, Page 21-14.
Speed Controller Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning on page 1-2.
2. Remove the rear body access panel.
3. Remove the two screws (5) from the speed controller cover (1) and remove the cover (Figure 23-12,
Page 23-13).
4. Disconnect all wires and multi-pin connectors from the speed controller (Figure 23-13, Page 23-14).
5. Remove the three self-tapping screws (17) that hold the controller (6) to the component mounting plate
and remove the controller from the vehicle.
Speed Controller Installation
1. Install the three self-tapping screws (17) that hold the controller (6) to the component mounting plate and
tighten to 60 in-lb (6.8 N·m) (Figure 23-13, Page 23-14).
2. Using the wiring diagram, install the multi-pin connectors and all wires as illustrated. See Wiring Dia-
gram on page 21-2. Tighten bolts (1) to 9 ft-lb (12.2 N·m) (Figure 23-13, Page 23-14).
3
Figure 23-12 Speed Controller Cover
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Solid State Speed Controller
5
1
2
23
Page 23-13