Table of Contents
Advertisement
SECTION 29 – IQ DISPLAY MODULE (IQDM-P)
PROGRAMMING
ý
DANGER
• See General Warning on page 1-1.
ý
WARNING
• See General Warning on page 1-1.
PLUGGING THE HANDSET INTO THE VEHICLE
1. Connect one end of the cable to the jack located on the bottom of the handset.
2. Connect the cable adaptor to the IQDP-P cable.
3. Find the IQDM jack on the vehicle (Figure 29-1, Page 29-1 or Figure 29-2, Page 29-1).
4. Remove the dust cap from the IQDM jack.
5. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack.
Figure 29-1 IQDM Jack On F&R Switch Housing
Figure 29-2 IQDM Jack Under Instrument Panel
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
29
Page 29-1
Advertisement
Table of Contents
Troubleshooting
