Club Car XRT 800 Maintenance Service Manual page 459

Gasoline/electric

Table of Contents

MOTOR (MODEL 5BC59JBS6390)

Figure 26-1 Lift Vehicle with Floor Jack

5. Remove both rear wheels.

6. Remove the nut, cup washer, and bushing from the bottom side of the shock absorber. Compress the

shock absorber (pushing upwards) to move it out of the way (Figure 26-3, Page 26-3).

7. Remove the nuts and bolts mounting the rear leaf springs to the shackles.

8. To gain easier access to the motor, lower the transaxle as low as it will go. If more room is needed,

remove the jack from beneath the transaxle and allow the springs to rest on the floor (Figure 26-3,

Figure 26-3 Lower Axle

9. Remove the four bolts that mount the motor to the transaxle (Figure 26-18, Page 26-14). See following

• Do not position fingers under motor when sliding motor off of the input shaft in step 9.

Fingers may get pinched when motor disengages.

10. Carefully slide the motor away from the transaxle until the motor spline disengages the input shaft and

remove the motor from the vehicle.

Figure 26-2 Vehicle Supported on Jack Stands

2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual

Troubleshooting