DSC PowerSeries PC1616 Installation Manual page 19

PowerSeries - PC1616/PC1832/PC1864
[019] Seventh System Option Code
Option Description
[1] For Future Use
[2] For Future Use
[3] ON: When disarming, the keypad will display only the first alarm to occur during the last arming period.
OFF: When disarming, the keypad will display all zones that were in alarm during the last arming period
[4]-[5] For Future Use
[6] ON: the green LED indicator on the keypads indicate the status of AC on the system
OFF: the green LED indicator on the keypads indicate the partition ready status
[7] ON: All user access codes can enter the User Functions menu.
OFF: Only the Master Code can enter the User Functions menu.
[8] For Future Use
[020] Keypad Zone Assignment
Enter the two-digit zone number to be assigned to each keypad assigned to a specific slot. Only one keypad can be assigned to a specific slot.
See Keypad Assignment. Valid entries are from [00] to [64].
[021] Eighth System Option Code
Option Description
[1] ON: Access codes will not be accepted by the system during entry delay.
OFF: An access code can be used to disarm the system during entry delay
[2]-[5] For Future Use
[6] ON: Key-switches and wireless keys can only disarm the system during an entry delay
OFF: Key-switches and wireless keys can disarm the system regardless if entry delay is active or not.
[7]-[8] For Future Use
[022] Ninth System Option Code
Option Description
[1] ON: An access code is required for access to the [,][1], [,][2], [,][3] menus.
OFF: No access code is required for [,][1], [,][2], [,][3] menu access.
[2]-[3] For Future Use
[4] ON: Only the Master code can be used to bypass a hold up zone.
OFF: Any valid access code can bypass a hold up zone.
[5] For Future Use
ON: RF Delinquency Enabled, if any wireless zone supervisory transmission is not received by the PC5132 during a 15-minute period,
[6]
the PC5132 will place the panel into Not Ready To Arm mode. In the armed state, the Zone faults will generate tamper alarms. The panel
will generate a silent trouble (NO trouble beeps but the Trouble LED is turned ON) called "RF Device Delinquency", which is only
viewable in [,][2] (Trouble Menu). The user can override the condition and arm the panel by using the feature.
OFF: RF Delinquency Disabled, the system will not indicate an RF Delinquency when a zone supervisory transmission is not
received during a 15 minute period.
[7] Future Use
ON: When the system is armed in Stay mode, during the Exit delay, the system will sound one beep every 3 seconds.
[8]
OFF: When the system is armed in Stay mode, the system will be silent during the Exit delay.
[023] Tenth System Option Code
Option Description
ON: the keypad [F] emergency key will only beep three times to acknowledge that the button has been pressed. The system will not
[1]
activate the bell output. OFF: the system will activate the bell output and beep the keypad.
For Future Use
[2]
[3] ON: the system will only transmit the Test Transmission reporting code if the system is armed at the time the system is programmed
to report the event. OFF: the system will always report the Test Transmission reporting code at the programmed time.
[4] ON: the system changes the Test Transmission Reporting Cycle Time from Days to Hours.
OFF: the Test Transmission Reporting Cycle Time is in Days.
16