Chorus; Extra Voice - Hammond A-405SP Owner's Manual

80
In this mode, you adjust the setting for the Chorus eff ect. Chorus aff ects only for the
Extra Voice division.
To locate this mode:
1 2

EXTRA VOICE

1. LEVEL
Th is sets the Level of the Chorus eff ect.
Th e setting range is 0 - 127.
2. TYPE
Th is sets the Types of Chorus eff ect.

Chorus 1, 2, 3, 4:

These are conventional chorus eff ects. They give spaciousness and depth to the sound.
FB Chorus:
This is a chorus that produces an eff ect similar to a fl anger. It softens the sound.
Flanger:
This creates an eff ect reminiscent of a jet airplane taking off and landing.
3. RATE
Sets the modulation frequency of the Chorus eff ect.
Th e setting range is 0 to 127. Th e higher the value, the faster the frequency.
4. DEPTH
Sets the modulation depth of the Chorus eff ect.
Th e setting range is 0 to 127. Th e higher the value gets, the deeper gets the modula-
tion.
5. FEEDBACK
Sets the amount of feed back of the Chorus eff ect output to the Chorus eff ect again.
Th e setting range is 0 to 127. Th e higher the value, the more feed back.
6. SEND TO REVERB
Sets the amount of the output of the Chorus eff ect to send to the Reverb eff ect.
Th e setting range is 0 to 127.
NOTE: CHORUS - TYPE is a macro parameter that allows global setting of chorus parameters.
When you select the CHORUS - TYPE, each chorus parameter (except #6) will be set to
the most suitable value.
NOTE: All the parameters in these modes are Preset Parameters. They are recorded into the
Combination Preset.
CHORUS
Touch the [MENU] button for the MENU, select page D by the [PAGE] button, and
then touch [2] CHORUS button.
3
Owner's Manual
4 5 6